DASY8/6 Module WPT V2.0: Enhanced and Fast WPT Compliance Testing
SPEAG released DASY8/6 Module WPT V2.0, which integrates the new MAGPy Version 2 with the DASY8/6 system and provides 8-times faster, more accurate, and total field (magnetic and electric field) compliance testing of sources emitting any periodic signals (<10 MHz) against the basic restrictions.
The latest version of our DASY8/6 Module WPT, V2.0, is now based on MAGPy Version 2 and takes full advantage of this stand-alone product. Evaluating wireless power transfer (WPT) systems has never been so quick and easy with maximum precision:
8× faster measurements, as the new probes allow assessment of the eight isotropic magnetic (H-)field probes (23 sensors plus phase) at each robot position;
Simultaneous measurement of the incident electric (E-)field with its integrated isotropic E-field sensor;
Evaluation of periodic signals with non-sinusoidal waveforms and duty cycles;
Evaluation of all basic restriction quantities, now also including the local non-averaged induced E-field required by ISED;
Conversion of the measured H-field distribution into a Maxwell field and calculation of the fields in the standardized phantom without loss of precision (Tier 4 of IEC 63184);
This user video shows how the MAGPy Version 2 probe, integrated with DASY8/6 Module WPT V2.0, is used to determine compliance for wireless power transfer devices.
Another important advantage is the dual use of the MAGPy system as a hand-held system (MAGPy Version 2) and as part of Module WPT (DASY8/6 Module WPT V2.0), as customers only need to buy and calibrate one device.
If you have any suggestions or would like to receive further information, please contact us at email@example.com.
SPEAG is pleased to announce the final release of SEMCAD X Matterhorn V15.0. Over the past three years, a complete overhaul of the previous version of SEMCAD X was undertaken, including improvements to all of its industry leading features; the replacement of inefficient and uncompetitive components; and the creation of the most modern user interface.
With the steady shipment of one cSAR3D FLAT unit per week successfully underway, SPEAG is now ready to ramp up cSAR3D HEAD production with the goal of also shipping three to four calibrated HEAD units per month. A demo video highlighting the exceptional functionality and user-friendliness of the system, including the new camera modules, is now available.
SPEAG is pleased to announce the release of cSAR3D software version 1.2. New features include improved 3D extrapolation, continuous measurement mode, and several enhancements of the graphical user interface. We are in full production with deliveries of two to four units per month.